Reviews Computer Room Air Conditioner

Well you've your new air cooling system installed and so are happy along with your decision to generate the investment. It was worth every penny and you've got no regrets. To keep your new air conditioner working at peak efficiency for a whole lot of years you need to begin a regular maintenance program that also includes changing the filter.

This is but one of the most significant things you can do to get the best performance out of your ac and heating equipment. By switching your air conditioner filter and not allowing it to become dirty and restrict air flow you may enable the environment conditioner to function with minimal power consumption, reduce the probability of break downs and keep the level of dust within your home with a minimum.

As the environment conditioner filter or furnace filter becomes dirty it's going to gradually start to restrict air flow from the system. Air conditioners are built to possess a certain amount of air flow for each and every ton of cooling. Four hundred cfm per ton to be exact. As the filter becomes dirty it will reduce air flow to the point that air flow falls below these design parameters.

When this happens it creates the consequence of low load conditions for the air conditioner and also the operating pressures begin to drop. Under normal conditions the evaporating temperature within the system will probably be above 32 degrees Fahrenheit.

Because this evaporating temperature is below the room temperature, and the dew point temperature, condensation forms for the evaporator coil through the air as it passes through the evaporator coil. This is great because it helps conserve a comfortable humidity inside your home. The condensation drips from your evaporator and drains away from your unit.

When an aura conditioner filter becomes dirty enough to reduce air flow, it has the identical effect for the system as low load conditions. When ac equipment operates under low load conditions the evaporator coil can ice up. Once ice actually starts to form, the situation gets progressively worse and finally a block of ice forms round the evaporator high is virtually no air flow.

The ice forms because because the heat load on the system diminishes the evaporating temperature in the evaporator starts to drop. When the evaporating temperature drops below 32 degrees Fahrenheit frost begins to form around the evaporator coil.

As frost begins in order to create it further reduces the level of air flow as well as the situation becomes worse. As mentioned before when equipment is in a situation to operate like this, eventually the evaporator will become a block of ice and also the unit could have to become turned off and able to thaw.

If this example occurs it may also damage the evaporator on the point where it actually starts to leak refrigerant and may even even have to be replaced, which will likely be very expensive.

There are also conditions that may cause these symptoms but this can be one of the most common. Frost forming using one in the lines being released in the air handler is an indication of low air flow among other things. The initial thing to do is look at your air conditioner filter before calling for service.